Winchester Brass 32 Winchester Special. Winchester Reloading Brass was produced to extremely tight tolerances so as to ensure smooth feeding and positive chambering. This Brass consistent case-to-case capacity and weight delivers outstanding accuracy. Winchester’s high quality, durable brass can be reloaded multiple times. New, unprimed brass. This is not loaded ammo.

Winchester Brass Preparation: Sometimes with bulk rifle brass one may  notice a few case mouths are “out of round” or very slightly dented down the shoulder.  These defect occur in the final tumbling wash operation after the case mouth has been annealed. Most Brass producers are aware of the case cosmetics and have been working to mitigate it, but due to the equipment design, denting may still occur. Winchester Brass 32 Winchester Special. However, some Minor dents are normally removed in the first firing and will not affect case life or the performance.  Whereas, On non-plated brass, one may still notice all the anneal stain might not be polished off, which can give the case neck a pinkish color.  With some lower caliber cases you may notice the case mouths to be slightly belled.

Best Practices: With all new rifle brass, the case and case mouth should first be straighten out, then chamfer and debur the case mouth inside and out.  To straighten the case mouth, run the case part way into the sizer die and let the expander ball straighten the brass.  Be sure to lubricate the case neck inside the case mouth to prevent the case neck from stretching.

Special care must be taken to lubricate the cases prior to sizing if using Nickel plated brass. Nickel plating is harder than brass and the cases require more effort in sizing.  In the scenario where a case becomes stuck, purchase a stuck case remover; don’t use pliers, screwdrivers or other common household tools which could damage your sizing die. Winchester Brass 32 Winchester Special.